If commands are set by AT command, please refer to <serial Readme> to install ES310 device
driver and set hyper terminal
You can contact our technical support to ask for device driver and <serial Readme>.
.
If everything is ready, then follow me to enjoy the AT command trip.
3.7 Step 7: Set APN, Report Server IP (AT)
Note: AT command is based on the command in <ES310 protocol>.
If you are not in China or America, APN is necessary to change.
The command to re-set APN and server IP is “GPRS”. The format of “GPRS” is shown below.
For example:
The APN of China Mobile is CMNET
The reporting server is esky car online platformThe default password is the
000000
So the AT command content should be:
at*cmd=”gprs,000000,cmnet,0,
Report server
APN
Password
AT command mark
at*cmd=” XXX “
Summary of Contents for ES310
Page 19: ...Figure 7 Add Device Pop up ...
