KK-EPA.004 Rev No:0 28.09.18
10
6.2.3 Setting Calibration Method
Your device has been calibrated during production. If you want, you can do this calibration according to
your sensor. To do that you should select the calibration method on this menu.
6.2.3.1 Factory calibration (default)
The default calibration on your device. The multipoint calibration or the two pointed calibration that you
have made to your device does not disturb the factory calibration.
6.2.3.2 Two-point calibration
By two-point calibration option, only the maximum and minimum points are selected. For example; While
you are calibrating a 10 cm linear potentiometer, the minimum point is identified when the potentiometer
is in the fully closed position and the maximum point is identified when the potentiometer is in the fully
open position.
* After you set the CAL-L value, you can do the same for the CAL-H value.
6.2.3.3 Multiple (segmented) Calibration
With the multiple calibration option, you can calibrate your device at up to 10 different points. This
method increases the linearity of the sensor.
For example; If the length of the sensor is 40 cm and you want to calibrate at 5 different points, these
points are; There may be 0. cm, 10. cm, 20 cm, 30 cm when sensor starts and 40 cm points where the
sensor ends. These points can be set anywhere in the scale range. We recommend you to choose by equal
intervals for a more suitable linearity.
6.2.3.4. Determining the Number of Calibrations (CL.CNT)
If you select the multi-segmented calibration option, in this menu that appears, you can specify the
number of points you want to calibrate the device.
It's a maximum of 10.
FCAL
2_Pnt.
SEGnt.
Factory calibration (Default)
CL.Cnt.
3
3
When the PRG button is pressed and entered into the menu, the second line starts blinking. Enter the desired value using
the UP and DOWN buttons and confirm by pressing the PRG button again.
START
CAL-L
XXX
.donE.
Multiple (Segmented )
Calibration
2 pointed calibration
CL.Cnt.
10
10
