9
Kongsberg XL
9. How To Procedures, Advanced
9.1. Cutting Thick Materials
When preparing materials with thickness between 45 – 50 mm (1¾ - 2 in.), the following rules
apply:
• No
Camera
operations are available.
• Disable
Measure Material Thickness
.
• Disable the
Depth Referenced from Top
function.
• This function is for
Knife Tools
only.
Cutting Depth when Depth Referenced from Top is disabled
Note:
This function is useful for all materials with an un-even surface.
9.2. Hard Board Production
To prepare hard board materials, the
procedure is as follows:
1.
Mill through the top layer using
MultiCUT
.
2.
Cut through the mid-section using the
HF
VibraCut Knife
.
3.
Mill through the bottom layer using
MultiCUT
.
1.
Ensure that the
milling bit
is sharp and proper for the job.
2.
Ensure that the
Knife Blade
is sharp and proper for the job.
41
