13
Kongsberg V-series
Remove the knife adapter from the tool and
insert the upper part into the tool position.
Position the tool adapter onto the shaft.
Observe
Alignment Pin
orientation.
Keep the knife adapter in this position while
you turn the tool shaft…
…in order to lock the tool adapter in its
position.
How to set the cutting depth of the VIxx Knife Tool
The default cutting depth is to cut through the entire material.
Define the depth of the bevel cut in the
Layer Setup
.
Normally, the cut should extend down to just above the bottom liner.
After a blade change, the tool depth should be checked again.
About tool adjustment
For the
VIxx Knife Tool
, we recommend the manual procedures for tool rotation and centre
offset adjustment.
Use a thin
Folding Carton
material when adjusting tool rotation and centre offset.
Remember that you should look at the bottom side of the material for correct alignment.
The adjustments depend upon the actual material due to weight, structure and thickness.
For optimal result, a fine tuning of the adjustments in the actual material should be carried
out.
For more information about how to run the adjustment wizards, see
Tool Configuration
.
126
