13
Kongsberg V-series
2.
Remove the sliding sleeve from the tool.
3.
The
Knife Blade
is held by a hex-screw. A 1.5 mm key will fit.
4.
Loosen the hex-screw and insert the new blade.
5.
When inserting the new blade, please make sure that:
a.
The back of the
Knife Blade
is aligned along the reference edge of the blade socket. (To
ensure blade perpendicularity).
b.
3 mm of the blade protrudes from the blade socket (X-acto #11).
6.
Tighten the hex-screws and reattach the knife tool.
For this tool, complete the following adjustments:
Parameter
Description
Tool Height
The foot should touch the material surface, see above.
Lag Setting
The knife lag depends upon the actual knife blade adapter and knife
blade.
Tool Rotation
Adjust tool angle tangential to moving direction.
Center Offset
Adjust tool sideways until centered.
Tool Offset
Adjust offset relative to
Laser Pointer
.
For more information about how to run the adjustment wizards, see
Tool Configuration
.
13.13
Psaligraphy Knife
Note:
iPC version 2.0 or higher is required to run this tool.
Psaligraphy Knife
is a tool for
cutting of fine details in paper and
folding carton.
Lag
is nominal 0 mm.
113