
OPERATING THE ENGINE
6
EN
GLISH
STOPPING THE ENGINE
A
If equipped with a turbo-charger, allow the engine to
idle for 5 minutes before shutting it off after a full load
operation.
Failure to do so may lead to turbo-charger trouble.
CHECKS DURING OPERATION
While running, make the following checks to see that all
parts are working correctly.
B
Radiator Cooling water(Coolant)
To avoid personal injury:
A
Do not remove radiator cap until
coolant temperature is well below its
boiling point. Then loosen cap
slightly to the stop position, to
relieve any pressure, before
removing cap completely.
If the coolant temperature warning lamp lights up or if
steam or coolant does not stop squirting from the radiator
overflow pipe, turn off the load and
keep the engine
idling (COOLING-DOWN) for at least 5 minutes
to let it
cool down gradually. Then stop the engine and take the
following inspection and servicing.
1. Check to see if the coolant runs short or if there is any
coolant leak;
2. Check to see if there is any obstacle around the
cooling air inlet or outlet;
3. Check to see if there is any dirt or dust between
radiator fins and tube;
4. Check to see if the fan belt is too loose; and
5. Check to see if radiator water pipe is clogged.
B
Oil pressure lamp
The lamp lights up to warn the operator that the engine oil
pressure has dropped below the prescribed level. If this
should happen during operation or should not go off even
after the engine is accelerated more than 1000rpm,
immediately stop the engine and check the following:
1. Engine oil level (See "ENGINE OIL" in "PERIODIC
SERVICE" section.)
1. Return the speed control lever to low
idle, and run the engine under idling
conditions.
2. Set the engine stop lever to the "STOP"
position.
3. With the starter switch placed to the
"SWITCHED OFF" position, remove the
key. (Be sure to return the engine stop
lever to the "START" position to be
ready for the next start.)
(1) Engine stop lever
(2) Speed control lever
(A) "STOP"
(B) "START"
(C) "IDLING"
(D) "OPERATION"
E.book 6 ページ 2012年6月8日 金曜日 午前11時47分
Summary of Contents for KPG Series
