ESI Artesia Pro XJam, User Manual, Page: 20 / 40

•
Select the pad on which you want to apply the MIDI channel setting to by pressing
it.
•
All pads between 1 and 10 will light up RED.
•
Compose the MIDI CH number using the 1-10 pads (10 means 0). At each press
the pads will turn YELLOW.
•
Press Pad 16 / ENTER to confirm the selection and exit SETUP.
5.3.5 SETUP Sending Notes Mode
Note: As mentioned under 4.1.1 Sending Notes, Xjam o ff ers two di ff erent modes to
send MIDI notes and CC data,
Temporary
mode and
Toggle
mode. By default Xjam
operates in Temporary mode.
To apply the TOGGLE MODE to all pads:
•
Press the SETUP button to enter SETUP mode.
•
Press Pad 5 / TOGGLE .
•
At this time your Xjam will directly exit SETUP mode and turn on the TOGGLE
function.
Note:
When you press the SETUP button again now, you will notice that Xjam now
shows a new SETUP state. When TOGGLE mode is ON, Pad 5 / TOGGLE will show
up RED for two seconds. If Xjam is in TEMPORARY mode (TOGGLE is OFF), this
pad is illuminated GREEN.
5.3.6 SETUP After Touch Settings
Xpad can either operate under polyphonic Aftertouch or Channel Pressure mode. Of
course it can also run without sending any Aftertouch data (OFF).
To activate Aftertouch or Channel Pressure for all pads:
•
Press the SETUP button to enter SETUP mode.
•
Press Pad 6 / AFT .
Page of 18 37