Using COMP (Compare) Function
“COMP”
function compares the measurement inputs with the pre-set
HI
and
LO
limits. The compare function calculation expression is based on
counts without decimal point.
HI:
Measurement value > High (HI) limit value
LO:
Measurement value < Low (LO) limit value
PASS: High limit value
≥
Measurement value
≥
Low limit value
When
“COMP”
function is enabled, the actual measuring value will be
shown in primary display and a comparison result
“HI”, “LO”
, or “
PASS”
will be shown in secondary display.
The beeper will sound three tones as the result is changed from “
PASS”
to
“HI”
or
“LO”
, and one tone from
“HI”
or
“LO”
to “
PASS”
.
Notes:
1. The Compare function can be used with other arithmetic functions such as
REL, MINMAX, and dBm modifiers
2. For frequency measurement, it will be locked to the range user is in when user
enters this mode will become the selected range.
Operation Procedures
then followed by
to enable the
“COMP”
function.
then followed by
again to disable the
“COMP”
function.
Setting a Compare Limit / Percentage Value
Using the following procedure to set the HI and the LO limit values for
“COMP” / “Percentage”
function:
then followed by
to enter the HI limit setup mode.
The HI limit will be shown in primary display.
,
,
or
to change this value.
to store the HI limit value in counts.
then followed by
and repeat the above steps to set and store
35