ets-lindgren.com
EMControl Command Set
83
*SRE
Description:
Set Service Request Enable Register. Changes contents of the
Service Request Enable Register.
Requires an integer argument in the range of 0 to 255. This
argument, when expressed in binary form, represents the value
of the eight-bit Service Request Enable Register.
The bits of the argument (with the exception of bit 6 which is
unused) correspond to the bits of the Status Byte Register.
Setting a bit in this register allows the corresponding bit in the
Status Byte Register to generate a Service Request.
Devices:
Turntables, towers
Syntax:
*SRE XXX
XXX
: Integer value representing eight-bit binary
number 0
–255
Response:
no response, or an error (error number)
Example:
Write
sd*SRE 32\n
: Allow the Event Status Bit to generate an
SRQ
See Also:
*SRE?
,
*STB?
Summary of Contents for ETS-Lindgren EMControl 7006-001
