ESCO Technologies ETS-Lindgren EMControl 7006-001, User Manual

Page: 21 / 91

ets-lindgren.com Operation 21
P
OWER
O
N
Note: If no devices are connected to EMControl, or if they are
connected improperly, dashes will display on the screen when the
power is turned on.
Note: Verify all cards are installed correctly in the EMCenter. Verify
all devices are properly connected to the EMControl card.
1. Plug the power cord from the mains inlet on the back panel of the
EMCenter into a power outlet.
2. Plug the interlock jack into the interlock connector on the back panel of
the EMCenter.
3. Turn the power switch located on the back panel of the EMCenter to
the on position.
4. Touch anywhere on the EMCenter screen. It will take approximately
20 seconds to boot. The Information screen will flash, and then the
Home screen will display.
Sample EMCenter Home Screen