Esaote MyLab XPro75, Getting Started

Page: 59 / 144

M Y L A B O V E R V I E W
MyLab
- G E T T I N G S T A R T E D 3 - 9
GETTI
NG STARTED
Two USB ports (17) are located on the right side of the control panel next to
the touchscreen. These ports can be used to connect an USB device for digital
storage. The lateral port can be used instead to connect USB foot-switch or a
USB printer.
Control Panel Assembly Orientation
The Control Panel Assembly is adjustable to accommodate a wide range of
operator heights and operating positions.
. These adjustments can be controlled by two levers located below the Control
Panel Assembly (as shown in the image beside).
The orientation lever (5), located on the left, allows to rotate by up to 50°
clockwise (with intermediate steps) and by up to 180° counterclockwise
(closed position for optimal handling). Push the lever to rotate the control
panel into the new position; release it when the control panel is correctly
positioned.
CAUTION
When rotating the keyboard, pay attention not to damage the peripherals
placed on the console. If the peripheral falls down, injury may be caused.
The lifting lever (13), located on the right, allows to adjust the position of the
control panel vertically, lifting or lowering it.
Push the lever and act on the handle to adjust the height of the control panel.
This lever allows a vertical displacement of

25 cm

Pull-out Qwerty Keyboard (12)
Beneath the Control Panel there is a pull-out alphanumeric keyboard. The
keyboard is mounted on a sliding drawer: just pull it to extract the keyboard.
The keyboard is used to enter patient data, comments and text annotation on
images.
22 Knob controls
23 TCG slide controls
24 Trackball
Number Control Panel Assemble