Esaote MyLab XPro75, Getting Started

Page: 47 / 144

A D D I T I O N A L I N F O R M A T I O N O N S A F E T Y
MyLab
- G E T T I N G S T A R T E D 2 - 17
GETTI
NG STARTED
Wireless safety
MyLab
is equipped with built-in wireless capability.
If the equipment is not installed and used in accordance with the instructions,
the equipment may cause harmful interference to radio communications.
NOTE
The wireless capability has to be considered as an intentional RF (Radio
Frequency) transmitter as indicated by the symbol:
When the wireless is active,
MyLab
might interfere with other equipment.
When wireless is active, the following safety precautions should be observed:

Maintain a minimum distance of 20 cm (8 inches) or more
from the antennas of the equipment and the body of patient
and operators. If a shorter distance is needed to work,
temporarily switch the wireless device off.

Use in specific environments:

the use of wireless devices in hospitals is restricted to the
limits set forth by each hospital.

the use of wireless devices in hazardous locations is
limited by the constraints posed by the safety directive of
such environments.
MyLab
is equipped with a standard Wireless LAN RF receiver and transmitter
module that uses the following frequencies:
MyLab
may be interfered with by other equipment, even if that other
equipment complies with CISPR emission requirements.
Receiver/Transmitter Band
[MHz]
Modulation
Maximum Transmitter Power
[dBm]
2400 to 2483.5 DSSS and OFDM 20
5150 to 5350 OFDM 23
5470 to 5725 OFDM 23