Esaote MyLab SigmaVET, Getting Started, Page: 55 / 134

S Y S T E M O V E R V I E W
MyLab
- G E T T I N G S T A R T E D 3 - 11
GETTI
NG STARTED
Basic mobile configuration
In its basic configuration (picture above), the trolley is supplied with holders
for probes, cables and gel. Insert the holders on the trolley lateral stirrups and
place them in the desired position.
The trolley provides a handle and independent brakes on four wheels to be
easily moved. It has also compartments to house the AC/DC adapter and the
probes.
Fixing MyLab on
trolley
Place
MyLab
on the top surface of the trolley, allowing it to slide to the
bottom, so that the profiles of the base match the housings. Secure
MyLab
to
the trolley, screwing on the captive screw located under the top surface.
WARNING
Make sure that the captive screw is completely screwed. If it is not secured
correctly,
MyLab
could come out of the housings and drop down.
WARNING
Do not use the lateral stirrups to push the device.
The
MyLab
AC/DC adapter can be placed on the dedicated tray of the trolley.
At working site At the examination site, position the equipment so that the power outlet is
easily accessible.
Adjust the device into its final position and then lock it to fix the position.
This assembly can be pushed up/down to maximize operator comfort.
A lever lock is placed on the back of the trolley near the handle.
Push the lever and act on the handle to adjust the height of the control panel.
This lever allows a vertical displacement of ±23 cm.
Rotate the LCD into its working position. Connect the probes and all
accessories.
Plug the power cable into the reliable grounding power outlet to assure
adequate grounding.
NOTE
Whenever
MyLab
has to be insulated from the mains, disconnect the cable
from the power outlet.
WARNING
When installing
MyLab
, check that the power cable is not tightly bent, that
it can’t be squashed by a misplaced foot or by heavy objects.