Esaote MyLab SigmaVET, Getting Started, Page: 102 / 134

C U S T O M I Z I N G M Y L A B
MyLab
- G E T T I N G S T A R T E D 6 - 16
WARNING
The displayed Sweep Velocity is correct as long as you do not use a
secondary monitor and/or an incorrectly calibrated monitor.
Field ACTION ON FREEZE
Various actions can be associated at
FREEZE
pressure; the available options are
listed in the table below.
Table 6-6: Actions on freeze
1-CLICK CHANGEOVER
ENABLED FOR PW,
CW, M-MODES
When checked, pressing PW from B-Mode,
MyLab
switches to B-Mode Doppler live at once.
When not checked, pressing PW from B-Mode,
MyLab
switches to B live + PW frozen. This step allows to position
the beamline into the target vessel and it is necessary then to
press PW once again.
The same behaviour applies to CW and M Modes.
INVERT CFM AND
DOPPLER SCALE
When checked, it makes the palette/scale inversion
completely independent, even when the automatic inversion
controlled by the steering is enabled (i.e. invert PW
spectrum without inverting the CFM scale).
Fields Action
Fields Action
NO ACTION When
FREEZE
is pressed,
MyLab
goes in freeze
without any other action associated.
GENERIC
MEASUREMENTS
When
FREEZE
is pressed,
MyLab
goes in freeze with
the trackball linked to the generic measurements menu.
GENERIC
MEASUREMENT CINE
When
FREEZE
is pressed,
MyLab
goes in freeze with
the trackball linked to cineloop.
APPLICATION
MEASUREMENTS
When
FREEZE
is pressed,
MyLab
goes in freeze with
the trackball linked to application measurements menu.
APPLICATION
MEASUREMENT CINE
When
FREEZE
is pressed,
MyLab
goes in freeze with
the trackball linked to cineloop.
BODYMARK When
FREEZE
is pressed,
MyLab
goes in freeze with
bodymarks active.
ANNOTATIONS When
FREEZE
is pressed,
MyLab
goes in freeze with
annotations active.