Esaote 350009500, Getting Started, Page: 47 / 114

MyLab
- G E T T I N G S T A R T E D
4 - 7
GETTI
NG STARTED
Turning the System On
Once the installation has been completed,
MyLab
is ready to be powered up. Press
the ON/OFF key to turn the system on.
CAUTION
Do not turn the system off while working (for example saving data) or
during the initialization phase: the hard disk could be damaged by this
operation.
Probes Connections
Both imaging and Doppler probes can be
connected to the two (2) connectors, on
the back of the system, indicated by
symbols EA1 and EA2.
Connector-securing devices are placed
beneath the probe connectors, on the
bottom side.Make sure that the securing
device is positioned in the lower position
(open position) and carefully attach the
probe connector by placing the cable
feedthrough frontwards. To secure the
probe, move the securing device up.
WARNING
Do not touch the probe connector pins or the system probes receptacle.
Never disconnect the probe while it is active. Press the FREEZE key before
disconnecting the probe.
CAUTION
Make sure to correctly align the probe connector before inserting it. Close
the securing device only after the complete insertion of the connector.