ESAB Railtrac BV2000, Instruction Manual, Page: 19 / 28

5 OPERATION
0463 629 001 - 19 - © ESAB AB 2018
5.5 Remote control for digital wire feeder
It is possible to adjust the maximum value on the remote control output (0-10 V) both for wire
feed speed and voltage. The maximum value is 0.5 V lower than V
in
(10 V) due to the
voltage drop in the opto driver.
Set Wire Feed Speed (WFS)
1. Press Menu once.
The display shows: DigF max WFS
2. Press + or - to adjust the setting.
Scale value: 1 - 40
Higher value gives higher output.
Set Voltage (V)
1. Press Menu until DigF max V is shown in the
display.
2. Press + or - to adjust.
Scale value: 1 - 40
Higher value gives higher output.
5.6 Installation of wire feeder
The installation must be carried out by a professional.
Railtrac™ BV2000 can be connected to one of the following wire feed units:
Aristo® Feed 3004, Aristo® Feed 4804, Origo™ Feed 304, Origo™ Feed 484 and
Warrior™ Feed 304.
For necessary adaptation between Railtrac™ BV2000 and the used wire feed unit (including
choice of control cable), see the "ACCESSORIES" appendix to this manual.
Universal feeder connection
For the operation of Railtrac™ BV2000 from other wire feeders (none ESAB), use
transformer unit and control cable according to the "ACCESSORIES" appendix.