ESAB Railtrac BV2000, Instruction Manual, Page: 14 / 28

5 OPERATION
0463 629 001 - 14 - © ESAB AB 2018
5 OPERATION
General safety regulations for handling the equipment can be found in the "SAFETY"
chapter of this manual. Read it through before you start using the equipment!
5.1 Electronic – Carriage
1 Start left
One press: Start left without welding
Double press: Start left with welding
Press 2 seconds: Start with fast move left
One press after start: Speed carriage -
2 Menu/Stop
Before start: Selector for programming
parameters. Blinking display indicates
progamming modus. Adjust parameters using
the
+ and - buttons.
After start: Stop carriage and welding.
If function Length : Press for 3 seconds to set
start position. Display shows 0 .
3 Start right
One press: Start right without welding
Double press: Start right with welding
Press 2 seconds: Start with fast move right
One press after start: Speed carriage +
Menus
Program P0 to P5, Railtrac™ BV2000 has 6 different welding programs.
Weaving width 0–60 mm (0–2.3 in.)
Space weaving
strings 1.0–10.0 mm (0.039–0.39 in.)
Speed weaving 5–40 mm/s (0.20–1.6 in./s)
Length 1–200 cm (0.39–79) length in program 3
Speed carriage 20–1500 mm/s (0.79–59 in./s)
0-line adjustment In steps of 0.5 mm (0.020 in.)
WFS Wire Feed Speed 1–99% (only for Esab wire feeders)
Volt 1 – 99% (only for Esab wire feeders)