ESAB CIGWELD WeldSkill 205AC/DC, Operating Manual

Page: 29 / 72

Manual 0-5555 4-1 OPERATION
SECTION 4:
OPERATION
4.01 Overview
Conventional operating procedures apply when using the Welding Power Source, i.e. connect work lead directly
to workpiece and electrode lead is used to hold electrode (Consult the electrode manufacturers information
for the correct polarity). The welding current range values should be used as a guide only. Current delivered
to the arc is dependent on the welding arc voltage, and as welding arc voltage varies between different classes
of electrode, welding current at any one setting would vary according to the type of electrode in use. The
operator should use the welding current range values as a guide, then finally adjust the current setting to suit
the application.
4.02 WeldSkill 205AC/DC Power Source Controls and Features
A-13992
1
2
3
4
5
6
7
8
9
10
11
12
13
15
14
20
16
17
18
19
22
21
Figure 4-1: Controls on Front Panel
1. Positive Welding Terminal
Positive Welding Terminal. 50mm2 Dinse Type. Welding current flows from the Power Source via heavy
duty bayonet type terminals. It is essential, however, that the male plug is inserted and turned securely
to achieve a sound electrical connection.
!
CAUTION
Loose welding terminal connections can cause overheating and result in the male plug being
fused in the Dinse terminal.