OPERATING MANUAL
Transmig 255i
Transmig 255i
MIG (GMAW) WELDING
5-4
Manual 0-5550
5.02 Attaching the Tweco Professional Fusion MIG Torch (Euro)
Fit the MIG Torch to the power source by pushing the MIG torch connector into the MIG torch adaptor and
screwing the plastic torch nut clockwise to secure the MIG torch to the MIG torch adaptor.
MIG Gun Adaptor
MIG Gun Connector
Art # A-10927
Figure 5-3: Attaching MIG Torch
5.03 Installing Spool (300mm diameter)
As delivered from the factory, the unit is fitted with a Wire Spool Hub which accepts a Spool of 300mm diameter.
Remove the locking pin from the spool hub.
Install the wire spool over the spool hub, locating the hole in the spool, with the alignment pin on the spool hub.
Insert the locking pin back into the spool hub.
Art # A-13928
Spool Hub Locking Pin
Spool Hub Aligenment Pin
Figure 5-4: 300mm Spool Installation