5 OPERATION
0459 293 787
- 18 -
© ESAB AB 2018
5
OPERATION
General safety regulations for handling the equipment can be found in the "SAFETY"
chapter of this manual. Read it through before you start using the equipment!
5.1
Connections and control devices
1
Orange indicating lamp - Overheating
10
Fuse for supply voltage for feeder unit,
42 V
2
White indicating lamp - Power supply ON
11*
*Only on WeldCloud™ version:
Connection for Ethernet
3
Main power supply switch, 0 / 1 / START
12*
*Only on WeldCloud™ version: Measure
outlet screw terminal - RED (+)
4
Connection (-) for return cable at SMAW
and GMAW or for welding current cable
at GTAW
13*
*Only on WeldCloud™ version: Measure
outlet screw terminal - BLACK (-)
5
Connection for remote control
14
Connection for control cable to the wire
feed unit or for the terminating resistor
6
Connection (+) for welding current cable
at SMAW or for return cable at GTAW
15
Connection for control cable to the wire
feed unit or for the terminating resistor
7*
*Only on WeldCloud™ version: Antenna
16
Connection (+) for welding current cable
to the wire feed unit
8*
*Only on WeldCloud™ version: USB
Connectivity
17
Connection (-) for the return cable wire
feed unit
9*
*Only on WeldCloud™ version: Red
indicating lamp - Wi-Fi Connectivity
