ESAB Aristo Mig 4001i, Instruction Manual, Page: 10 / 26

4 INSTALLATION
0460 740 001 - 10 - © ESAB AB 2017
4 INSTALLATION
The installation must be carried out by a professional.
4.1 Lifting instructions
4.2 Location
Position the welding power source such that its cooling air inlets and outlets are not
obstructed.
4.3 Mains supply
NOTE!
Mains supply requirements
This equipment complies with IEC 61000-3-12 provided that the short-circuit
power is greater than or equal to S
scmin
at the interface point between the user's
supply and the public system. It is the responsibility of the installer or user of the
equipment to ensure, by consultation with the distribution network operator if
necessary, that the equipment is connected only to a supply with a short-circuit
power greater than or equal to S
scmin
. Refer to the technical data in the
TECHNICAL DATA chapter.