9
VIVO-I103(M)/ VIVO-I203(M)
Quick installation and programming guide
English
WARNING
This quick guide is a summary of the complete installation manual. The manual contains safety warnings and
other explanations which must be taken into account. The most recent versions of this guide and the
installation manual are available at the "Downloads" section on Erreka's website.
http://www.erreka-automation.com
The options and functions described in this guide apply for the firmware version indicated on the circuit. The
firmware, as part of a process of continuous improvement, is subject to new functionalities or upgrades being
included as a result of new versions which are not necessarily compatible with previous ones. For this reason,
some options or functions may differ or be unavailable if your firmware is older than shown in this guide.
Electrical wiring
A
:
Main power supply
B/F
: Flashing light with antenna
C
:
Photocells (Rx/Tx)
D
:
Key switch
E
:
Operator
Elements of the complete installation
NOTE
: this control panel is valid for operators
for the following types of door and gate:
swing (
C301
),
sliding (
C302
),
up-and-over (
C303
).
VERY IMPORTANT: the
TC
closing stopper and the
TA
opening stoppers must be installed.
VIVO-I203:
VIVO-I203M:
230V, 50-60Hz
125V, 50-60Hz
S.EXT./
S.CIE.
S.INT./
S.APE.
A.P./C.
A.T./A.
P294Z2
F2
F1
DL27
JP1
3~
M
1~
M
JP1
Pos 1
Pos 2
230V
230V
Power supply and peripheral cabling (valid for all cases)
(resistive)
(resistive)
F1
: 3A fuse
F2
: 0.5A fuse
DL27
: LED Continuous
Bus
EPS1
: traffic light card
(with parameter
Ab00
) or
b r a k e c a r d ( w i t h
p a r a m e t e r
A b 0 1
, s e e
connection diagram on
p a g e 1 2 ) . S e e o t h e r
options on page 16.
See the Display
indications on
page 12.
MSA
-115/00
Firmware V0.15 or later