Network Video Recorder Quick Start Guide
5
Figure 1. 1
MVINVR-08POEHP-E
Table 1. 2
Description of Rear Panel Interfaces
No.
Item
Description
1
Power Supply
AC 100~240V for MVINVR-08POEHP-E.
2
Audio In
RCA connector for audio input.
3
HDMI Interface
HDMI video output connector.
4
LAN Network Interface
1 10 /100 /1000 Mbps self-adaptive Ethernet interface
5
Audio Out
RCA connector for audio output.
6
VGA Interface
DB9 connector for VGA output. Display local video output and menu.
7
USB Interface
Universal Serial Bus (USB) ports for additional devices such as USB
mouse and USB Hard Disk Drive (HDD).
8
Ground
Ground (needs to be connected when NVR starts up).
9
Power Switch
Switch for turning on/off the device.
10
Network Interfaces with
PoE function
Network interfaces for the cameras and to provide power over Ethernet.
Installation and Connections
1.3
NVR Installation
During installation of the NVR:
1.
Use brackets for rack mounting.
2.
Ensure ample room for audio and video cables.
3.
When routing cables, ensure that the bend radius of the cables are no less than five times than its diameter.
4.
Connect the alarm cable.
5.
Allow at least 2cm (
≈0.75-inch) of space between racks mounted devices.
6.
Ensure the NVR is grounded.
7.
Environmental temperature should be within the range of -10
ºC to 55
ºC, 14ºF to 131ºF.
8.
Environmental humidity should be within the range of 10% to 90%.
1.4
Hard Disk Installation
Before you start:
Disconnect the power from the NVR before installing a hard disk drive (HDD). A factory recommended HDD
should be used for this installation.
Up to 8 SATA hard disks can be installed on your NVR.
Tools Required:
Screwdriver.
Steps (for DS-8600NI-E8):
1.
Remove the cover from the NVR by unfastening the screws on the back and side.
