Network Camera User Manual
164
Appendix 2 Port Mapping
The following settings are for TP-LINK router (TL-WR641G). The settings vary
depending on different models of routers.
Steps:
1.
Select the
WAN
Connection Type
, as shown below:
Figure A.2.1 Select the WAN Connection Type
2.
Set the
LAN
parameters of the router as in the following figure, including IP address
and subnet mask settings.
Figure A.2.2 Set the LAN parameters
3.
Set the port mapping in the virtual severs of
Forwarding
. By default, camera uses
port 80, 8000 and 554. You can change these ports value with web browser or client
software.
Example:
When the cameras are connected to the same router, you can configure the ports of
a camera as 80, 8000, and 554 with IP address 192.168.1.23, and the ports of another
Summary of Contents for MicroView MVIB-04IR-E
