ERNITEC MicroView MVIB-01IR-E, User Manual

Page: 158 / 172

Network Camera User Manual
157
the correct password to unlock it.
Notes:
•
The memory card can only be read and written in when it is unlocked.
•
If the camera, which adds a lock to a memory card, is restored to the factory
settings, you can go to the HDD Management interface to unlock the
memory card.

Remove the Lock
(1)
Select the Lock Switch as OFF .
(2)
Input the correct password in Password Settings text field.
(3)
Click Save to save the settings.
4.
Set the Arming Schedule and Linkage Method , if you want to receive a
notification when the health status of the memory card is anything other than good.
Refer to Task 2: Set the Arming Schedule for Motion Detection and Task 3: Set
the Linkage Method for Motion Detection in Section 10.1.1.
5.
Click Save to save the settings.
Configuring Lite Storage
Purpose:
When there is no moving object in the monitoring scenario, the frame rate and bitrate
of the video stream can be reduced to lengthen the storage time of the memory card.
Notes:
 Lite storage function varies according to different camera models.
 The video files recorded in lite storage mode will be played back in full frame rate
(25fps/30fps), and thus the playback process is speeded up to the eye.
1.
Enter the Lite Storage interface:
Configuration > Storage > Storage Management > Lite Storage
2.
Check the Checkbox of Enable to enable the lite storage function.
3.
Input the storage time in the text field. You can view the available space of the SD
card on the page.