ERNITEC MicroView MVIB-01IR-E, User Manual

Page: 107 / 172

Network Camera User Manual
106
6.
Set the arming schedule and linkage method as in the normal configuration mode.
7.
Click Save to save the settings.
 Day/Night Scheduled-Switch
Steps:
1.
Draw the detection area as in the normal configuration mode. Up to 8 areas are
supported.
2.
Select Scheduled-Switch for Switch Day and Night Settings .
Day/Night Scheduled-Switch
3.
Select the start time and the end time for the switch timing.
4.
Select the area by clicking the area No..
5.
Slide the cursor to adjust the sensitivity and proportion of object on the area for
the selected area in the daytime.
6.
Slide the cursor to adjust the sensitivity and proportion of object on the area for
the selected area at night.
7.
Set the arming schedule and linkage method as in the normal configuration mode.
8.
Click Save to save the settings.
10.1.2
Configuring Video Tampering Alarm
Purpose:
You can configure the camera to trigger the alarm when the lens is covered and take
certain alarm response actions.
Steps:
1.
Enter the video tampering Settings interface, Configuration > Event > Basic
Event > Video Tampering .