OSD Setup Manual
www.ernitec.com
34
When the settings cannot be applied, the following message will be
displayed. Try to reduce the resolution or FPS of the IP camera. Note that
the login account of the IP camera should has administrator authority.
Cannot set the IP device
Otherwise, the <Device Setup> setting is completed.
NOTE:
After changing any item under Device Setup menu, users
MUST set <Apply> to <Yes> to apply the changes, or the settings
will remain unchanged.
Activated
Access this item and select <Yes> to activate the connection to the IP camera. To
deactivate the connection, select <No>
NOTE:
Once the connection to the IP camera is activated, menu items
<Hostname/IP>, <Model>, <Connection Setup> will be grayed out and
cannot be accessed.
Status
After the connection to the IP camera is activated, users can check the connection
status. The menu will be shown as below
.
Status
Model
Streaming Format
Resolution
PPS
Bandwidth
Pkg. lost rate
****
MJPEG
720*480
10
20 KB/Sec
0.1%
The information shown on the monitor is “ready only”.
