ERNITEC EDNS V3000 Series, User Manual

Page: 83 / 124

82
Ernitec EDNS V3000 series – user manual
www.ernitec.com
V 2.2.082012

If there is no any exportable device connected to the DVR
unit, a warning message will be shown on the screen

Press ENTER to start the export the whole event video to the
connected device; or, press ESC to abort.
4.5 Dome Control
The DVR allows users to control a dome camera by the front
panel. In Live mode, users can press CHANNEL key to display
the desired dome camera in full screen. To enter Dome Control
mode, press the DOME key. To exit Dome Control mode and
return to live mode, press ESC or DOME.
4.5.1 Dome Connection
Follow the steps to install dome cameras.

See Setup Guide for RS-485 port pin definition.

Connect the R+, R- terminals on the dome camera to the D+,
D- terminals on the RS-485 port by RS-485 cable respectively.
Refer to the connection figure illustrated in Setup Guide .
4.5.2 Dome Protocol Setup
The Dome Protocol item lists the available dome protocols for
communicating with dome cameras connected to the DVR. From
the Main menu, select <Camera Setup> and press ENTER. The
following menu is displayed.
Camera Setup
Analog Camera Select
Dome Protocol
Dome ID
Camera Name
Hidden
Brightness
Contrast
Saturation
Hue CH01
None
0
CH1
No
0
0
0
0
To configure dome protocol, select a camera first and set the