ERNITEC EDNS V3000 Series, User Manual

Page: 49 / 124

48
Ernitec EDNS V3000 series – user manual
www.ernitec.com
V 2.2.082012
3.6.8 Per Channel Config
This menu is used to configure the <Video Loss Detect>,
<
Motion Detect>, <Alarm In> and <Alarm Out> settings for each
channel. The menu is displayed as below.
Per Channel Config
Channel Select
Video Loss Detect
Motion Detect
Detection Config
Alarm In
Alarm Out
CH01
Off
Off
ENTER
OFF
OFF
3.6.8.1 Channel Select
The item is used to select a desired channel for setting the
parameters. Move the cursor to <Channel Select> and press
ENTER, then select a channel using UP / DOWN keys. Press
ENTER again to confirm the selection.
3.6.8.2 Video Loss Detect
This item allows users to enable or disable Video Loss as an
alarm event. Select <On> to enable Video Loss alarm events, or
<Off> to disable.
3.6.8.3 Motion Detect
This item allows users to enable or disable motion detection
function of the DVR. Select <On> to enable Motion Detect alarm
events, or <Off> to disable. If motion detection function is
enabled, it is required to define motion detection parameters
such as detection area and sensitivity settings in <Detection
Config>.
3.6.8.4 Detection Configuration
If motion detection function is enabled, it is required to define the
motion detection parameters such as detection area and
sensitivity settings. Select a channel for setting the parameters,
move the cursor to <Detection Config> and press ENTER. The
Detection Configuration menu displays as follows.