Ericsson SVP 2000, Reference Manual, Page: 58 / 196

Encoder Web-based GUI Control
Table 4.4 Publishing Tabbed Page – RTP Output Item Descriptions
Group Item Description Notes
Ethernet interface Ethernet plug to which to deliver
the output audio/video stream.
This stream is an MPEG-2 SPTS
containing the encoded or
transcoded audio/video stream. Choices are:
- Ethernet Plug #1
- Ethernet Plug #2
A usual setting is to set video
network on plug #
IP address IP address to which to deliver the
output audio/video stream. This can be a unicast IP address or
a multicast IP address
Port
First UDP port to which to deliver
the output audio/video stream.
This must be an even port. This
port and the 3 subsequent ports
will be used respectively for video
RTP, video RTCP, audio RTP,
and audio RTCP streams. For instance, if UDP Port is set to
5004, the following ports will be
used, all on the same destination IP
address:
- 5004 for video RTP
- 5005 for video RTCP
- 5006 for audio RTP
- 5007 for audio RTCP
Send SAP
announces Enable SAP announces
Interface
Use default session
name The default session name will be
used in SDP file
FEC FEC mode Mode used to calculate Forward
Error Correction for audio/video
stream Choices are:
None
Basic, FEC on row packets only
Level A, FEC on column packets
only
Level B, FEC on both column and
row packets
Caution!
DVB-Teletext, DVB-Subtitle, KLV, SCTE-35 can only be delivered to RTP-TS output
mode; and a Decoder can make use of them only if it itself delivers to TS mode.
EN/LZT 790 0046/1 R1A 4-12