Quick Start Guide: Connect-Power-Configure
•
The unit will automatically decode the first video component that it finds within
the selected service.
•
An alternative video component may be selected from the service tab on the
Web Control interface.
•
If the incoming video is successfully decoded then the status
OK
should be
displayed on the appropriate page.
•
Successfully decoded High Definition video will be output from the connector
marked
Video Component
.
•
Successfully decoded Standard Definition video will be output from the
connector marked
CVBS
.
3.6
Configuring the Audio Outputs
When configuring the Audio Outputs the following points should be observed:
•
The unit will automatically decode the first two audio components that it finds
within the selected service.
•
Alternative audio components may be selected from the service tab on the Web
Control interface.
3.7
Configuring for Single-service Decryption
When configuring for Single-service Decryption the following points should be
observed:
•
If the service selected for video decode contains encrypted components these
components will automatically be decrypted by the unit.
•
The outgoing feed from the unit will contain these decrypted components
providing the TS feed on the
Output
tab on the Web Control interface is set to
descrambled
.
3.8
Configuring for Multi-service Decryption
When configuring for Multi-service Decryption the following points should be
observed:
•
With Director Multi-service Decryption, when a feed containing more than one
encrypted service is applied to the unit, the first 24 services detected are
automatically decrypted. A list of these services can be found in the service
table on
Services
Menu.
•
With Common Interface Multi-service Decryption, when a feed with more than
one encrypted service is applied to the unit, the user may choose how it is
decrypted using the
Maximum CAM Services
,
Maximum CAM Components
EN/LZT 790 0008/2 R1A
2011-03-30
12 (36)
