Ericsson RX1290, Reference Manual

Page: 166 / 176

Menus
Display Title: Setup Description
XXXXXXXXXXXXX FRONT PANEL
SERIAL REMOTE (not supported in software version
1.0.0)
NETWORK (SNMP)
LCD Contrast XXXXXX XXXXXX is editable in the range:
LOW
MEDIUM
HIGH
Serial Remote Protocol
XXXXXXXXXXXXXXXXXXXXX XXXXXXXXXXXXXXXXXXXXX is editable:
RS-232 TTV, RS-232 ALTEIA AT ADDR YYY, RS-485
ALTEIA AT ADDR YYY where YYY is CR address
from 000 to 999.
IP Address
XXX.XXX.XXX.XXX XXX.XXX.XXX.XXX is the editable IP address
Subnet Mask
XXX.XXX.XXX.XXX XXX.XXX.XXX.XXX is the editable subnet mask
Gateway Address
XXX.XXX.XXX.XXX XXX.XXX.XXX.XXX is the editable Gateway address
Syslog Address
XXX.XXX.XXX XXX.XXX.XXX is the editable Syslog address.
Restore System Defaults Restores system defaults.
Service Hunt Mode
XXXXXXXX XXXXXXXX is the editable parameter for setting
automatic service selection (ENABLED, DISABLED)
SI Mode
XXX XXX is the editable parameter for SI detection (AUTO,
ATSC, DVB)
Customization Key
XXXXXXXXXXXXXXXXXXXXXX XXXXXXXXXXXXXXXXXXXXXX is the editable
parameter for entering customization keys
C.10.2 Multi-Format Receiver Details Menu
The Multi-Format Receiver Details submenu displays the software, firmware,
hardware, PLD version and electronic serial number of the CR.
Table C.38 CR Details Menu
Display Title: CR Details Description
Electronic Serial Number
XXXXX XXXXX is the unit serial number
Software Version XX.XX.XX is the software version number
EN/LZT 790 0003/2 R1A C-24