Ericsson iPECS-100, Feature Description And Operation Manual

Page: 415 / 464

iPECS-LIK
Feature Description & Operation Manual
Issue 6.1
374
6.19 SYSTEM CLOCK SET
Description
The System Attendant can set the system Time/Date.
Operation
System Attendant
To set the system clock
1. Press the [PGM] button.
2. Dial
“041”, the Attendant Station Program code.
3. Dial six (6) digits for the Date (MM/DD/YY) or [SAVE] to skip the Date.
4. Dial four (4) digits for the Time (HH/MM) or [SAVE] to skip the Time setup.
5. Press the [SAVE] button, confirmation tone is heard and Attendant station returns to
idle status.
To set the system clock through ISDN message
1. Press the [PGM] button.
2. Dial
“046”, the Attendant Station Program code.
3. Dial
“1” to set DATE/TIME using ISDN message.
4. Press the [SAVE] button, confirmation tone is heard and Attendant station returns to
idle status.
Conditions
1. The time is entered as a 24-hour (military) clock, 24-hour mode.
2. If an NTP server is assigned, the system will check the time every ten (10) minutes.
If the system time is more than 10 seconds off of the NTP time, the system time is
reset. This will override the Attendant setting.
Programming
SYSTEM 1 Network Time/Date (PGM 161-Btn 12)
2 System Attendant (PGM 164-Btn 1)
3 System Time (PGM 178-Btn 1)
4 System Date (PGM 178-Btn 2)
5 DST Enable (PGM 178
– Btn 3)
6 DST Start & End Time (Web only)
7 NTP Active (PGM 195
– Btn 1)
8 NTP Sever address (Web only)
9 Std system time, local Time Zone (Web only)