Ericsson iPECS-100, Feature Description And Operation Manual

Page: 202 / 464

iPECS-LIK
Feature Description & Operation Manual
Issue 6.1
176
3. The alternative route employs a Speed Dial number to place a call and is not a
Networked call. Thus, the Distributed Control Network features are not available.
Programming
Related Features
Hardware
2.70.2.1 Net Call
Description
A station user can make a call to a station in other systems by dialing only a station number
just as an intercom call within the same system.
Operation
1. Lift Handset or press the [SPEAKER] button. The system provides a user with a
dial tone.
2. Dial the station number of other systems, or press the {NET DSS} button of other
systems.
3. The station seizes the network CO line according to the net routing table, and the
system sends a digit stream that is modified by the net routing table.
4. The called party receives a digit stream that is sent by calling party, and analyzes it
using the net routing table to determine.
5. The right destination. The called station receives a ringing signal.
6. The LED of [Network CO] button will be extinguished when the Net Call is cleared.
Conditions
1. Net call must be used without seizing a CO line.
2. User hears an error tone if there is no idle networking path.
3. In spite of ICM mode, the called party receives a ringing signal for the networking
call.
4. When system detects the fatal error from the network, system sends the digit
stream to the network using the alternate speed dial bin. In this case, the call is not
a networking call.
5. The Net Call is also applied CO Call Restriction Timer (PGM180-Btn14).
Programming
SYSTEM 1 Networking Basic Attributes (PGM 320)
2 Networking CO Line Attribute (PGM 322)
3 Network Numbering Plan Table (PGM 324)
Related Features
Hardware