Ericsson EXN401, User Manual

Page: 31 / 180

Command Line Interface
The FTP connection is defined by using:
The FTP username defined using the
ip ftp username
command
(for more information, see “ip ftp username” section 2.6.6 on page 22)
•
•
•
The FTP password defined using the
ip ftp password
command
(for more information, see “ip ftp password” section 2.6.7 on page 22)
The FTP server location defined using the
ip file server
command (for more information, see “ip file server” section 2.6.8 on
page 23).
The TFTP connection uses the TFTP server location defined using the
ip
file server
command (for more information, see “ip file server” section
2.6.8 on page 23).
Default None
Modes Privileged EXEC
Requirement Need a management entry point since FTP/TFTP is used.
Example To download a new version of the software from an FTP
server that is stored in the file named
last
located in
directory
release
:
EXN400# update ftp:release/last
2.5.8 reload
Description This command is used to initiate a software reboot of the
EXN400. On reboot, the startup configuration is applied. If you made any
change in the configuration but did not save your configuration into startup
configuration before rebooting, your modifications will be lost.
Syntax
reload
Default None
Modes Privileged EXEC
Example
EXN400# reload
2.5.9 coldboot
Description This command is used to initiate a complete cold boot of the
EXN400. The difference with the
reload
command is that
coldboot
will
not only restart the software system but first run Power-On Self Tests
(POST). On cold boot, the startup configuration is applied. If you made any
1553-LZY 214 2655 C 2004-11-24
17