Bridging
EXN400(config-subscr)# no multicast
3.4.1.3.6 multicast-bpdu
Description
This command enables the flooding of BPDU multicast
frames. It has no effect if flooding is enabled for all multicast frames (see
section 3.4.1.3.5 above).
Syntax
multicast-bpdu
no multicast-bpdu
Disables flooding of BPDU multicast frames.
Default
Enabled
Modes
Subscriber-policy configuration
Example
To enable flooding of BPDU multicast frames:
EXN400(config-subscr)# multicast-bpdu
3.4.1.3.7 unknown-unicast
Description
This command enables the flooding of Unicast frames with
an unknown address.
Syntax
unknown-unicast
no unknown-unicast
Disables flooding of frames with unknown address.
Default
Disabled
Modes
Subscriber-policy configuration
Example
To disable flooding of Unicast frames with unknown address:
EXN400(config-subscr)# no unknown-unicast
3.4.1.3.8 router-addr
Description
This command is used to specify the IP address of the
default gateway in forced ARP forwarding mode implemented through a
Proxy ARP function. If a fixed IP address is configured, any bridge using
this policy must first be bound to a management entity, with an IP address
in the same subnetwork so that the gateway’s IP address can be resolved.
Syntax
router-addr {dhcp | ipAddr}
1553-LZY 214 2655 C 2004-11-24
99
