2. Scroll through the list using the RAMP control
, or . until one of
the first ten entries is reached.
NO ENTRY
is displayed if the location is
empty.
3. Enter the desired number. If necessary, a pause can be entered by press-
ing and holding 0-9, (*), or (#) until an underscore appears in the display.
The individual call list entries will accept up to 5 digits. The phone call
list entries accept a combination of up to 31 digits and pauses.
4. Press and hold
m
until the display changes indicating that the number
has been stored.
5. Repeat the steps above if the number stored in an entry location needs to
be changed.
MOBILE DATA
The ORION radios when operating in the EDACS configuration permit
either voice or data calls to be transmitted or received. The radio can handle
only one type of call at a time; however, selection of either data or voice is
selected transparently by the operator through normal usage of the radio.
Data communications is not supported in the conventional mode.
The mobile radios may be connected to Mobile Data Terminals (MDT) or to
a host computer. Any RS-232 compatible device that supports the Radio
Data Interface (RDI) protocol (Version 1.91 or greater) may be connected to
the mobile radio. Support for MDT’s or host computers is a programmable
option per radio. Additionally, radios programmed for host computers may
also be programmed for data only operation (no voice calls transmitted or re-
ceived).
Displays
The following will be displayed on the control unit during the various states
of data mode of operation.
TX DATA
Displayed on bottom line of display when the radio is trans-
mitting a data call.
RX DATA
Displayed on bottom line of display when the radio is re-
ceiving a data call.
47