Not
f
or Comm
e
rc
ia
l Use
E
ricsson Mobile
Com
m
unic
a
ti
ons A
B
72
Extra features
If there is a dash in a number, the handset waits a while for the dial tone. If
you hear the dial tone, the handset continues dialling without waiting for the
full dial tone pause period.
Some telephone networks use pulses when dialling a number. If your cordless
phone is set to pulse dialling, you can switch to tone dialling if required, for
example to control a teleservice.
To switch the handset to tone dialling during a call:
Route:
DialMode » GoToDTMF
•
Select
GoToDTMF
and press
Y E S
.
The handset now uses tone dialling.
When you hang up, the handset goes back to pulse dialling. The pulse dialling
setting stays when you switch off.
Which dialling method?
You can easily check whether tone or pulse dialling is required. Proceed as
follows:
1.
Check if the base station is set to tone dialling, see “Tone dialling” on
page 73.
2.
Press
Y E S
.
You hear the dial tone.
3.
Dial the number of someone you know.
If the external line supports tone dialling, you hear the phone ring.
If you dial the number and still hear the dial tone, you have to set the base sta-
tion to pulse dialling. See below.
Pulse dialling
1
To set the base station to pulse dialling:
Route:
BaseStation » Basic » PhoneLine
1.
Select
Basic
and press
Y E S
.
PIN:
is displayed.
2.
Enter the PIN code for the base station (see page 58) and press
Y E S
.
3.
Select
PhoneLine
and press
Y E S
.
The opposite of the current setting is displayed.
4.
Scroll to either
GoToPulse
or
GoToDTMF
. If the display shows:
•
GoToDTMF
press
N O
because the base station is already set to pulse
dialling.
•
GoToPulse
press
Y E S
to set the base station to pulse dialling.
PULSE OR TONE DIALLING
1.
This function may not be supported by your telephone network operator.
Summary of Contents for 230
Page 1: ......
