Operating Instruction
Spindle lifting system SLA/SLG VD
Document no.: B-00081
Edition 2019 02
Operating instruction EN
Copyright by Ergoswiss AG
14/20
5.5
Container-Stop and Shelf-Stop-positions
(Only with manual control switch type Memory!)
These two features can be used to limit the movement area of the lifting system (e.g. if a container is placed
underneath the desktop).
A Container-Stop position will be the new lowest end position, a Shelf-Stop position will be the new highest
end position.
To define a Container-Stop/Shelf-Stop position, proceed as follows:
1.
Press the button
M
8 times -> A signal tone will ring.
2.
Drive to the desired position and press the button
M
3 times.
3.
Press the button
or
the button
-> A signal tone will ring.
NOTE
If the button
is pressed, the upper position will be limited =
Shelf-Stop
If the button
is pressed, the lower position will be limited =
Container-Stop
NOTE
For a Container-Stop position and Shelf-Stop position, these steps must be performed sepa-
rately.
To deactivate an existing Container-Stop/Shelf-Stop position, follow the same procedure and redefine the
new end position.
5.5.1
Child-proof lock (Only with manual control switch type Memory!)
Activate child-proof lock:
→
Press the button
M
for 10 seconds.
The control box signalizes the activation of the child-proof lock with a signal tone.
When the child-proof lock is activated, any
Pressing any button on the manual control switch will show the warning A 101 or A 65 on the dis-
play.
Deactivate child-proof lock:
→
Press the button
M
for 10 seconds.
The control box signalizes the deactivation of the child-proof lock with a signal tone.
The system can now be operated normally.
5.6
Reset of the control box
1.
Drive the system to the programmed lowest position.
2.
Keep the buttons
and
pressed simultaneously.
System will drive to the lower block position and adjust itself like during the initial operation.
