Operating Instruction
Spindle lifting system SL/SM 13xx with SCT iSMPS
Document no : B-00361
Edition 2020 06
Operating instruction EN
Copyright by Ergoswiss AG
16/27
5.3
Limit the stroke length
These two features can be used to limit the stroke length of the lifting system (e.g. if a container is under
the table). The container stop position limits the lower end position, the shelf stop position the upper end
position.
5.3.1
Limit lower end position - Container-Stop
To define a Container-Stop position, proceed as follows:
1.
Keep the buttons
1
2
and
pressed simultaneously for 4 s.
-> The display shows «S01», while the S is blinking
2.
Press the button
or
until «S05» is selected.
3.
Confirm the selection «S05» with the button
M
.
-> The display stops blinking
4.
Press the button
or
to drive to the desired Container-Stop position.
5.
Confirm with the button
M
.
-> The display shows «S05»
6.
Press the button
1
2
or
3
to leave the menu mode.
To delete a set Container-stop position, a new one has to be done with the same procedure.
5.3.2
Limit upper end position - Shelf-Stop
To define a Shelf-Stop position, proceed as follows:
1.
Keep the buttons
1
2
and
pressed simultaneously for 4 s.
-> The display shows «S01», while the S is blinking
2.
Press the button
or
until «S04» is selected.
3.
Confirm the selection «S04» with the button
M
.
-> The display stops blinking
4.
Press the button
or
to drive to the desired Shelf-Stop position.
5.
Confirm with the button
M
.
-> The display shows «S04»
6.
Press the button
1
2
or
3
to leave the menu mode.
To delete a set Shelf-stop position, a new one has to be done with the same procedure.
