SanaBike 500 easy
Article-Nr.: 2.520132b
Revision: 10/2018
Page 16 of 21
When pressed, the screen changes to manual mode to manually control the load with the default start value
of 25 watts or the last defined load value. This value can be changed by the user by means of the two arrow
symbol buttons "down" and "up" in increments of 5 watts.
Which operating mode is currently activated will be shown by a circle symbol on the right side of the display
below the ergometry data.
•
No or red dot
= Load will be defined by master device (Remote operation)
•
White dot
= Load will be defined by the user (Manual operation)
Note:
While manual operation is active, the automatic control by the master device is deactivated. Here, the current ergometry
data will be transmitted from the ergometer to the master device but commands of the master device will be not accepted.
7.2.3
Starting, adjusting and terminating manual operation mode
The manual load definition will be started by activating the button
„
Start
“
in the middle of the display,
whereupon the manual defined load will be activated. A white dot at the lower right side signalize the activa-
tion of the manual operation mode. This dot is shown during the manual mode is active. If there is no dot or
a red dot visible, the ergometer is in remote operation wherein the load control will be performed by a mas-
ter device.
The manual mode can be terminated by pressing the „Exit“ button the t
ouch display.
Standard display
„
ergometry screen
–
manual operation
“
Operation mode symbol
Start display
„Manu
al mode
“
Increase load
by 5 watts
Decrease load
by 5 watts
Button
„Start“
Current value of
manual load
specification
Operating display
„Manu
al mode
“
Button
„
Exit
“
