ADDITIONS TO ASSEMBLY INSTRUCTIONS:
Please read this first before you start assembling your
desk base.
1)
The desk base does not come pre-assembled as in step 1 (the Lifting Column Assembly).
Go straight to Step 2 to start attach the telescoping rails to the sides of the lifting
column. It requires 2 bolts per side.
2)
For your convenience, we have included counter-sunk wood screws to affix the desk
base to the top as well as the motor and controller. The instructions say to use ‘pan-
head screws (not included)’; however we have found that the counter-sunk screws work
best. They will not poke through the desk top.
3)
We do recommend using a power drill to affix the desk base to the desktop. The top
does not come pre-drilled to allow for individuals to decide on how wide they want the
desk base to go. We recommend the top end mounting brackets be no more than 3”
from the desktop edge.
4)
Do not place any objects that are taller than 20” underneath the desk.
5)
Ensure the length of power cords are accounted for when operating the desk. Monitors,
computers, speakers, anything with a cord that is not long enough for the desk’s range
of motion could be pulled down or have its wires broken. Items pulled off the desk may
cause other items to fall.
6)
Once the desk has been assembled, adjust the feet levelers so that the desk is level and
does not shift its position. After this, connect the desk to the 110v outlet and the desk is
ready to be used.
7)
After it has been assembled, DO NOT lift the desk by the desktop. Lifting this way can
stress the fasteners connecting the desk base to the desktop. If you need to move the
desk, lower the desk completely and lift the desk by grabbing the top of the desk base
or by removing the desktop first.
