505 E. Hawley Street, Suite 210, Mundelein, Illinois 60060 (847)566-4950
Parts You Need to Purchase
You will need to purchase the screws listed below to attach the Monitor Mount to the Slatwall Hutch.
•
10-24 x 1 ¼ pan head Phillips screw (Qty 4)
You may also need to purchase longer screws to attach your monitor to the VESA base. Most monitors
will need
at least a 16mm long
M4-0.7 pan head Phillips screw (Qty 4).
Refer to your monitor
’s
user guide for specific information pertaining to the screw size need for your
model.
Tools Needed
•
Phillips screwdriver
•
Pliers
•
Drill
•
3/8”
Metal Drill Bit
•
Pencil
Installation
1.
Mark the spot where you would like the monitor mount located
on the Slatwall Hutch using the 2 ½”
diameter base and the
backing plate adapter as a template, then drill the 4 holes.
Make sure that the holes are located on the raised rib of the
Slatwall
.
2.
Attach the 2½” base to the front of the Slatwall and the backing
plate to the back of the Slatwall using the (4) 1 ¼” screws
(purchased by you). Tighten the (4) nylock nuts onto the end of
the screws using pliers.
Note: The 1” screws included with the
backing plate are too
short and should
not
be used.
Back of Slatwall Hutch
