Ergon Crafco SUPER SHOT 125, Parts Manual

Page: 40 / 176

Super Shot 125 DC 70CFM EU Part Manual
Chapter 5 Operating Instructions
©2022 by Crafco, Inc. All Rights Reserved
………………..…………………………………..….Operating Instructions 5-14
5.12 Mounting a Skid Machine
Step Action
WARNING
The truck needs to be of proper size to hold the loaded weight and size of the
machine and any extra material to be carried. The center of gravity of the loaded
machine should be above or in front of the rear main axle. Contact Crafco for help in
determining the location of the center of gravity of your machine before mounting.
WARNING
Only mount the unit to a metal truck bed or any other non-flammable surface that
can support the weight of the machine.
Failure to use the correct mounting surface could result in damage and
possible fire!
WARNING
Mount the machine a minimum of 3” (76mm) above the truck bed. Depending on the
machine and airflow, you may have to mount it higher to prevent excessive
temperatures on the machine and truck bed.
1
Mount with four ½” diameter Grade 5 bolts (or 12mm Grade 10.9) minimum, using
the loading tubes at each corner of the machine to secure it in place.
WARNING
Leave 15” (381mm) clearance around the machine. Keep this area clear of any
flammable material such as empty sealant boxes.
Failure to keep this area clear could result in damage and possible fire!
METAL TRUCK BED
BOLT LOCATION
(AND SPACERS
IF NEEDED)
BOLT LOCATION
(AND SPACERS
IF NEEDED)
TYPICAL SKID MOUNT GUIDELINES
SEALANT
STORAGE
AREA
INCH MINIMUM
CLEARANCE. MAY
NEED TO BE MORE
DEPENDING ON AIR
FLOW NEEDED FOR
BURNER BOX.
15 INCH (381mm) MINIMUM
CLEARANCE AROUND MACHINE
3
Table 5-11 Mounting a Skid Machine