Ergon Crafco 46200EB, Parts Manual, Page: 78 / 202

EZ 1000 Series II Melter Part Manual
Chapter 8 Troubleshooting
©2019 by Crafco, Inc. All Rights Reserved………………...………………………………..……………...Troubleshooting 8-12
Step Possible Cause If . . .
12a Is there 12Vdc between bottom terminal of
circuit breaker (red wire) and nearby ground
source (black wire)?
•
Yes, replace circuit breaker.
•
No, go to Step 13.
13 Is there 12Vdc between “ACC” (red wire) of
ignition switch and nearby ground source
(black wire)?
•
Yes, check for loose or broken wires
between “ACC” of ignition switch and
bottom terminal of circuit breaker.
•
No, go to Step 13a.
13a Is there 12Vdc between “B” (blue wire) of
ignition switch and nearby ground source
(black wire)?
•
Yes, replace ignition switch.
•
No, go to Step 14.
14 Is there 12Vdc between blue wire on starter
solenoid and nearby ground source (black
wire or bare metal on engine case)?
•
Yes, check for loose or broken wire
between starter solenoid and ignition
switch.
•
No, go to step 14a.
14a Check connections and condition of red
battery cable.
•
Yes, there should be 12Vdc at all previous
steps.
•
No, replace battery cable.
Table 8-12 Burner Electrical Troubleshooting – 3C Engine (continued)