Ergon Crafco 46200EB, Parts Manual, Page: 62 / 202

EZ 1000 Series II Melter Part Manual
Chapter 6 Maintenance Instructions
©2019 by Crafco, Inc. All Rights Reserved……………..…………………………………..….…Maintenance Instructions 6-3
6.28 Burner Fuel Filter Replacement
On machines that have a separate fuel filter for the burner, follow the steps below to replace the
fuel filter.
Step Action
1 The machine should be off, and cooled to ambient temperature.
2 Place a drain pan below the burner fuel filter assembly.
3 Close the ball valve that is located inline before the burner fuel filter assembly.
4 Unscrew the filter from the assembly using an oil filter or strap style wrench.
5 Screw the new filter into place, and tighten by hand.
6 Open the ball valve to allow fuel to flow.
7 Turn on the power key, and turn on the main power switch. The burner should self-
prime and start. It may take a couple cycles to fill the new fuel filter and bleed the fuel
system.
8 Once the burner is running, check for any fuel leaks, and tighten the filter if needed.
9 Turn off the main power switch and power key.
Table 6-9 Burner Fuel Filter Replacement