ergoline ergoselect 400, Operator'S Manual

Page: 28 / 56

- 28 -
o
PeratInG
m
odes wIth
C
ontrol
t
ermInal
K
An ergoselect ergometer with a control terminal K supports
the following operating modes:
PC MODE
An external device (e.g. stand‑alone electrocardio‑
graph, PC‑based ECG system) controls the ergometer ‑
no intervention at all is required at the ergometer.
ERGOMETRY
The ergometer runs an automatic exercise test ‑ some
of the corresponding test protocols are user‑configu‑
rable and stored in the system (see chapter "Settings").
TRAINING
Ten different training protocols with warm‑up, exercise
and recovery phases can be custom‑configured (see
chapter "Settings").
A POLAR receiver is integrated in the ergometer and
provides the relevant data for heart‑rate controlled
training sessions.
s
peed readout
1 speed low (patient should pedal faster)
2 correct speed
3 speed high (= patient should pedal slower)
Note
• If, during an exercise test, the speed drops below 30 RPM,
the load readout starts blinking on the display.
• To reactivate the saddle height adjustment function,
press and the arrow keys will again be displayed.
• Additional blood pressure measurements can be initiated
with .
TEST
Integrated test protocols (steep ramping test, PWC
tests) allow an assessment of the physical fitness.
MANUAL
The ergometer is controlled manually, i.e., the user
performs all load changes via the keypad.
SETTINGS
Used to configure the ergometer.
s
Peed readout
At the top of the control terminal, there is a speed readout
for the patient as well as three LEDs that inform the patient
of the speed: too slow, too fast or correct.
The ranges for the respective speed ratings depend on the
selected load (see "Technical Specifications").