ergolet LunaIPx4, User Manual

Page: 10 / 24

10
Pictograms and functions
(1) ON – If LED light is off, the Luna is in
“sleep” mode. The LED light will turn on when
the up (4) or down (3) button on the hand
control is pressed.
Side foil :
(2) BATT. – Indicates battery level (see 2.6).
(3) + (4) Up/Down – Press and hold the Luna
will move in the desired direction. Release the
button to stop the movement.
Note : Works only with hand control (5)
plugged in and LED light (1) must be on.
(5) Plug – Insert the hand control plug.
Hand control
:
(6) Data display – Information about the Luna
model, serial number and symbols
information.
(7) Emergency Lowering – ONLY used in
situations where it is necessary to lower a
patient safely in case of a lift failure. This
button must be held constantly to lower the
unit. (See section 2.5)
(8) STOP – Press the emergency stop button
to stop the Luna immediately. This function
can be reset by pressing the reset button on
the hand control for 5 seconds.
9) Reset – Used to reset the Luna after the
use of the emergency stop - or lock function.
Reset by holding the reset button for 5
seconds, the Luna will then be reactivated.
Reset can also be used to lock all functions to
avoid unintended use by e.g. the patient.
When the reset button is held, the LED light
will show red and all functions will be locked.
(10) Option – This option is not available on a
standard hand control. The extra output can
be e.g. the Luna Mover or an electrical
spreader bar.
(1) (2)
(3) (4)
(5) (6) (7) (8)
(9)
(7)
(8)
(10)
(4)
(3)
(2)
(1)