23
22
USE
01
INTENDED USE
This product is intended for drilling in wood and similar materials e.g. MDF, plywood etc,
plastic, metal and impact drilling in brick, tile, concrete, as well as for screw driving.
02
OPERATION
ON / OFF SWITCH (C)
Depress the on/off switch (11) to start and release it to stop your drill. The on/ off switch is
fitted with a brake function which stops your chuck immediately when you quickly release
the switch. It is also a variable speed switch that delivers higher speed and torque with
increased trigger pressure.
WARNING!
Do not operate for long periods at low speed because
excess heat will be produced internally.
SWITCH LOCK (D1)
The switch trigger can be locked in the OFF position. This helps to reduce the possibility
of accidental starting when not in use. To lock the switch trigger, place the rotation control
(5) in the centre position.
FORWARD/REVERSE ROTATION CONTROL (D2, D3)
WARNING!
Only change the rotational direction when the product
is switched off and has come to a complete stop! Always ensure that
the forward / reverse rotation control is adjusted to the correct position
depending on the intended operation!
Always push the forward / reverse rotation control as far as it will go! Do not
use the product with the control switch in any other intermediate position!
Move the forward / reverse rotation control (5) to the left in order to use the product in a
clockwise rotational mode
.
Move the forward / reverse rotation control (5) to the right in order to use the product in
anticlockwise rotational mode.
TWO-SPEED GEAR CONTROL (E)
The drill has a two-speed gear control designed for drilling or driving at LOW or HIGH
speeds. A slide switch is located on top of the drill to select either LOW or HIGH speed.
When using the drill in the LOW speed range, the speed will decrease and the drill will
have greater power and torque. When using the drill in the HIGH speed range, the speed
will increase and the drill will have less power and torque.
GEAR 1
Low speed range: for screw driving or working with large drilling diameter.
GEAR 2
High speed range: for working with small drilling diameter
BIT FITTING/REMOVING (F)
To fit a bit, loosen chuck sleeve to open chuck jaws. Insert the drill bit between the chuck jaws
and tighten chuck sleeve fully. Ensure the drill bit is in the centre of the chuck jaws. To
remove the bit, just loosen the chuck sleeve.
DRILL/SCREWDRIVER/HAMMER SELECTION RING (G)
Three working modes are available on this tool: drilling, screw driving and impact drilling.
To select any of the three modes, rotate the function ring to align it with icon of the drill/
screwdriver/ hammer on the housing, depending on the function you require
.
For screw driving
For drilling in wood and metal
For impact drilling in masonry and concrete
TORQUE ADJUSTMENT (H)
In screw driving mode, the torque can be adjusted by rotating the torque adjustment ring.
Higher number means higher torque. Select the setting as follows:
1 - 4 for driving small screws
5 - 9 for driving screws into soft material
10 - 14 for driving screws into hard wood
15 - 17 for driving larger screws
AUTOMATIC SPINDLE LOCK (I)
The automatic spindle lock allows you to use it as a regular screwdriver. You can give
an extra twist to firmly tighten a screw, loosen a very tight screw or continue working
when the battery energy has expired. For manual screwdriver purposes, the chuck is
automatically locked when the tool is off.
