Equinox Systems ISPnano I Series, User Manual, Page: 125 / 135

Distributor of Equinox Technologies: Excellent Integrated System Limited
Datasheet of ISPNANO S3 KIT - ISP PORTABLE PROGRAMMER
Contact us: sales@integrated-circuit.com Website: www.integrated-circuit.com
ISPnano Series Programmer - User Manual – V1.11 – 12
th
May 2011 108
3.2 ‘TARGET ISP’ Port
The ‘TARGET ISP Port’ connects directly to the Target IC to be programmed on the Target System.
It is a 16-way 0.1” pitch IDC connector. It has the same pin-out as the standard ISPnano
programmers. Please see Appendix 2 for full pin-out details.
3.3 ‘Remote Control’ Port
The ‘Remote Control Port’ provides all the necessary signals for remote controlling the programmer.
It is a 16-way 0.1” pitch IDC connector. It has the same pin-out as the standard ISPnano programmer
‘Remote Control Port’ . Please see Appendix 3 for full pin-out details.
3.4 ATE Port
The ‘ATE Port’ is only found on the ‘ISPnano Series 3 (ATE)’ version of the programmer.
The signals which would normally be connected from an ATE / ICT to the Target IC / Target System
(UUT) are instead connected to the ‘ATE Port’ . These signals are then routed via relays under
programmer control to the ‘TARGET ISP Port’ . The connector is a 14-pin IDC connector with 0.1” pin
spacing. The pin-out of this connector is detailed below.
ATE Port
The connector is a 14-pin bump-polarised IDC
connector with 0.1” pin spacing.
Pin 1 is the top right pin as shown in the diagram
opposite.
Pin
No Programmer
Pin name I/O Connect to
pin on
Target System Notes
1 Programmer I/O1 I/O
•
JTAG – TDI
•
SPI – MOSI
•
UART - TXD
This pin can be used for JTAG, SPI
or UART Target Systems.
2 Programmer I/O2 I/O
•
JTAG – TDO
•
SPI – MISO
•
UART – RXD
•
PDI_RXD
This pin can be used for JTAG, SPI,
UART, XMEGA PDI and ATtiny TPI
Target Systems.
3 Programmer I/O3 I/O
•
JTAG – TCK
•
SPI - SCK
This pin can be used for JTAG or
SPI Target Systems.
4 Programmer I/O4 I/O
•
JTAG – TMS This pin is used for JTAG Target
Systems only.
125 / 135
125 / 135